Import a cold backup copy that was run by a different appliance

If you have run cold backup copies on one appliance, you can import reference information about those copies to a second appliance. Once reference data has been imported, you are able to recover those copies by using the second appliance.

Use this procedure to view the cold copy sets that reside on media that is currently connected to the backup copy target and to import a set's reference information to the cold copy catalog on the appliance.

NOTES   

●   Backup copy jobs mount and unmount the target automatically. The target remains offline unless a copy job is running. To view sets, you must enable the target, which also imports reference information for any backup copies that were not found on the appliance.

●   A new cold copy format was introduced beginning in Unitrends release 10.1. If you attempt to import a cold copy and receive the message Failed to read archive file, verify that the appliance is running version 10.1 or higher. If not, install appliance updates, then try the import again.

●   To view additional cold copy job details, use the To view all sets in the cold copy catalog procedure instead.

●   There is no procedure to increase the number of concurrent cold copy jobs. They run serially.

1.  Connect the media containing the cold copies to the target appliance that will import the reference information.

NOTES   

If you need to remove a drive from an eSATA or USB dock, be sure to:

●   Power down the dock.

●   Swap the drive.

●   Power on the dock.

2.  Log in to the target appliance.

3.  On the Configure > Appliances page, select the appliance.

4.  Click the Backup Copy Targets tab below.

5.  Click Scan for Media.

view Sets On Media 1

6.  Select the cold backup copy target.

7.  (If needed) Click Enable to bring the target online. (If the target is already enabled, you see a Disable button instead and you can skip this step.)

NOTES   

If you receive a message that the media has not been initialized, you must erase or prepare the media before you can enable the target. Erasing or preparing the media removes all backup copies stored on the media. For details, see one of the following:

●   Prepare tapes for use with an autochanger device for tape autochanger targets.

●   Initialize and erase cold backup copy media for all other cold backup copy targets, including single tape drive devices.

view Sets On Media 2

8.  Select On Media from the View Sets list:

view Sets On Media 3

9.  Sets that are stored on the media display in a list. The following is given for each set:

●   Description – Name of the backup copy job that created the set.

●   Date – Date and time that the set was copied to the media.

●   Imported – Indicates whether the set's reference information has been imported to the cold target's catalog on this backup appliance. (Reference information must be imported so the set can be discovered in the Backup Catalog, where you can then opt to import the set's backup copies to the appliance. For details, see To import a cold backup copy.)

view Sets On Media 4

10.  Do one of the following:

●   To import a set's reference information, select it in the list and click Import to Catalog.

●   To exit, click Close.

Reference information is imported. You can now import the cold copies to the appliance. See To import a cold backup copy for details.